ROYAL KRAFT Linear or strip ceilings provide an aesthetic linear finish to any interior. Available in a variety of profiles and modules, including 84R, 84C,150F,150C and 300C The panels are available in coil coated or powder coated steel and aluminium substrates. Perforated profiles are available 2.2, 2.5mm and 1.8mm perforation for acoustic applications. Panels are available in lengths up-to 5-6 meters, to suit your design and site requirements. 84R LINEAR CEILING SYSTEM 84 R ceiling system comprises of 84 mm x 16 mm panels without flush profile (for 100 mm module only) roll formed out of metal coils. Panels are fixed on to roll formed carriers 32 mm wide x 39 mm deep made out of 0.9 mm Aluminium or 0.5 mm galvanised steel sheet with cut outs to hold the panels in module of 100 mm at maximum 1.5 mm without insulation and at maximum 1.2 m c/c with insulation. Carriers are suspended from the roof or truss by 4 mm dia. galvanized steel wire rod hanger with special height adjustment suspension clip at max. 1.2 m c/c. Hangers are fixed to the roof by ceiling bracket. Panels are available in max. Lengths up to maximum 5 m to suit site dimensions. Edge profiles or wall angles are 24 mm X 24 mm X 0.4 mm thick and match the colour of the panel. Flush profile can be use in between 2 panels to fill gap of 16mm. Material used for panels and Carriers: Aluminium Alloy AA5050, AA3105 or AA1050 is used to make the panels and carrier. Thickness is 0.5 mm for panels. carriers shall be 0.5 mm thick in G.I and 0.9 mm in aluminium. Panel are made of Galvanised steel with 100 gsm Zinc coating and 20 microns polyester paint coil coating sheets. Panels can be available in 60 microns polyester powder coating galvanized steel with 100 gsm Zinc coating or in aluminium alloy in different colours. Finish of the panels: Panels are available in plain and perforation of 2.2mm, 2.5mm and 1.8mm